Hook up refrigerator ice maker
Be sure to keep the spacing equal to prevent leaking. To install a needle valve or saddle valve, place the two clamps around the copper pipe and use a screwdriver to tighten the screws on each hook up refrigerator ice maker to hold the valve in place.
Now that the water line has been run to the refrigerator, it's time to do what's called the "tap-in" to the cold water line underneath the sink. About the Author Cecilia Harsch has been writing professionally since Push the refrigerator against the wall.
Next, tighten down the "T" handle until it's tight and pierces the copper line. Do not twist the nuts too tight as this could damage the supply valve, the supply line and the adapter.
The folks at GE Appliances recommend using a vertical pipe, if available. Turn the cold water supply valve on beneath the sink. Turn on the cold water faucet to drain any water left in the supply line.
Tapping the Cold Water Line
Slip the compression nut that came with the kit over the newly installed supply line. The first part of the icemaker kit is called the solenoid valve. Connect a Refrigerator to an Icemaker HammerZone. Let 1 or 2 gallons of water run through the new line to remove the air.
She writes mainly home improvement, health and travel articles for various online publications. Drain the Water Line Now that the water line has been run to the refrigerator, it's time to do what's called the "tap-in" to the cold water line underneath the sink.
The next step is to install the factory fill tube. Slide the provided water valve clamp over the fill tube, insert the water supply line and use a drill with a hex head bit to tighten everything up. Now move to the back and install the fill tube.
Turn off the supply line. Plug in the refrigerator.
Turn the cold water on the supply line clockwise to close it.